- HOME
- Support
- Products FAQ
- About the use of SSC (Spread Spectrum Clock)
Products FAQ
SupportProducts FAQAbout the use of SSC (Spread Spectrum Clock)
Electrical CharacteristicsV-by-One HS・LVDS
Unless otherwise noted in each product’s data sheet, no SSCG (Spread Spectrum Clock Generator) is implemented on our products.
If spread spectrum processing is needed for the LVDS output signals on non-SSCG implemented products, perform spread spectrum processing (Spread Spectrum Clocking) with the input clocks.
-References for THC63LVD Series' SS tolerance
-References for THCV Series' SS tolerance
* File open password : thine_member
If spread spectrum processing is needed for the LVDS output signals on non-SSCG implemented products, perform spread spectrum processing (Spread Spectrum Clocking) with the input clocks.
-References for THC63LVD Series' SS tolerance
-References for THCV Series' SS tolerance
* File open password : thine_member
FAQ in the same category
- When THCV220 is operating in Normal mode, pulses with negative polarity are emitted from BETOUT terminal.
- How do I calculate the data rate of a serial signal?
- Is any terminator built in the LVDS input?
- What does “100%” mean in the of Pre-emphasis specifications?
- Is there any basis for evaluating or measuring the transmission channels such as connectors and cables, etc. to be used with THCV series?
See the list of FAQ in the same category
Still looking for a solution?
Please contact us here.
Go to Technical Support Request
For other questions, such as Media Contacts, IR information, please find the best contact from Contact Us.