- HOME
- Support
- Products FAQ
- Can you suggest how I can omit HTPDN or LOCKN signal line?
Products FAQ
SupportProducts FAQCan you suggest how I can omit HTPDN or LOCKN signal line?
UsageV-by-One HS
In V-by-One® HS, AC coupling (capacitive coupling) is used for the transmission from the transmitter (Tx) to the receiver (Rx) through capacitance.
The standard recommendation is that the capacitor for AC coupling be placed just next to the Tx device’s CML output pin, but placing it just next to the Rx device’s CML input pin is allowed as well.
Performing capacitive coupling on both Tx and Rx prevents the DC between Tx and Rx from being propagated to CML terminals on both sides.
By using this feature, the signals which are sufficiently slower than V-by-One®HS signal, e.g. LOCKN, HTPDN and the power supply, can be transmitted through the V-by-One®HS signal line.
However, as the load on the V-by-One®HS signal line becomes larger with this method, the waveform of V-by-One® HS signal will be affected.
If you consider adopting this method, evaluate it sufficiently in advance under your usage environment before using it.
For details, refer to the application notes for each V-by-One®HS product (reference schematics) and here.
* Password : thine_member
The standard recommendation is that the capacitor for AC coupling be placed just next to the Tx device’s CML output pin, but placing it just next to the Rx device’s CML input pin is allowed as well.
Performing capacitive coupling on both Tx and Rx prevents the DC between Tx and Rx from being propagated to CML terminals on both sides.
By using this feature, the signals which are sufficiently slower than V-by-One®HS signal, e.g. LOCKN, HTPDN and the power supply, can be transmitted through the V-by-One®HS signal line.
However, as the load on the V-by-One®HS signal line becomes larger with this method, the waveform of V-by-One® HS signal will be affected.
If you consider adopting this method, evaluate it sufficiently in advance under your usage environment before using it.
For details, refer to the application notes for each V-by-One®HS product (reference schematics) and here.
* Password : thine_member
FAQ in the same category
- Does Cable Extension Kit transfer the camera data by Ethernet protocol? Can RJ-45 connectors on the kit connect to 10/100/1000 Ethernet?
- Caution about multi-stage (cascade) connection
- Is a single clock input system enough for the Dual Link (2port) LVDS receiver?
- LOCKN signals do not become stable.
- Can I use single coaxial cables for THCV series products?
See the list of FAQ in the same category
Still looking for a solution?
Please contact us here.
Go to Technical Support Request
For other questions, such as Media Contacts, IR information, please find the best contact from Contact Us.